Using the StorDigital DVD Duplicator + USB PC Connect (with switch model)

The new Stordigital USB adapter with a switch means you no longer need to scroll through internal menu settings to activate the I/O connection.
The first time you attempt to connect the duplicator’s USB port to your PC, your computer will need to load the copier’s drivers to its system. You will be presented with screens similar to this that relate to the new hardware/USB mass storage device.

 

Shortly after pressing ‘NEXT’, you will be presented with another message

You will need to press ‘CONTINUE ANYWAY’ to proceed.

The computer then searches for and loads the drivers for the duplicator’s DVD writer that is now connected to the PC as well as drivers for the duplicator’s ROM (reader)- which may also need your confirmation – this will take a few minutes, please be patient.

Your computer will notify you once the new hardware has been successfully installed and is ready for use.

To use the duplicator’s DVD writer via USB, the adapter’s switch on the rear of the duplicator should be set to the left (as seen from the back of the copier) – in this position, all remaining writers will be available for normal duplication tasks but first,  you must  SHUT-DOWN your duplicator and restart.

Upon successful reboot, the duplicator ( AUTOCOPY mode) will open all available writer trays – NOTE: the tray for the bottom writer will remain closed as the connected writer (usually the lowest one) is now temporarily part of the computer’s system and its status and contents may be viewed through My Computer.

Use a program such as Nero (supplied) to transfer and burn files directly to the duplicator’s DVD writer.

When you have finished using the USB connection and you wish to use all writers for duplication, set the switch to the right (as seen from the back of the copier) and re-boot the duplicator. 

You will need to press ‘CONTINUE ANYWAY’ to proceed.

The computer then searches for and loads the drivers for the duplicator’s DVD writer that is now connected to the PC as well as drivers for the duplicator’s ROM (reader)- which may also need your confirmation – this will take a few minutes, please be patient.

 

Your computer will notify you once the new hardware has been successfully installed and is ready for use.

 

To use the duplicator’s DVD writer via USB, the adapter’s switch on the rear of the duplicator should be set to the left (as seen from the back of the copier) – in this position, all remaining writers will be available for normal duplication tasks but first,  you must  SHUT-DOWN your duplicator and restart.

 

Upon successful reboot, the duplicator ( AUTOCOPY mode) will open all available writer trays – NOTE: the tray for the bottom writer will remain closed as the connected writer (usually the lowest one) is now temporarily part of the computer’s system and its status and contents may be viewed through My Computer.

 

Use a program such as Nero (supplied) to transfer and burn files directly to the duplicator’s DVD writer.

 

When you have finished using the USB connection and you wish to use all writers for duplication, set the switch to the right (as seen from the back of the copier) and re-boot the duplicator.